Article ID : 00197939 / Last Modified : 21/05/2019

How to delete registered information of all devices paired with the wireless speaker.

Is it possible to delete just one set of pairing information?

Applicable Products and Categories of This Article

Deleting just one set of pairing information is not supported by the wireless speaker. You need to delete all pairing information by initializing the speaker.
IMPORTANT: All settings of the wireless speaker are then returned to their factory defaults, hence, deleting all network settings and pairing information.

See below for how to delete pairing information by resetting the speaker to factory settings:

Model Name

Operating Instructions

CAS-1
  1. Turn off the unit.
  2. Press and hold the (on/standby) button of the unit for over 10 seconds while the unit is turned off, and the LEDs above the volume control will quickly flash.

GTK-XB60
GTK-XB90

  1. Turn on the unit.
  2. Press and hold the FUNCTION PAIRING button and the VOLUME - button at the same time for more than five seconds.
LF-S50G
  1. Turn on the unit.
  2. Press and hold the (microphone off) button until all four of the status LEDs light in orange.
LSPX-S1
  1. Turn on the unit.
  2. Press and hold the Volume (volume) - button and the on/standby (power) button simultaneously for five seconds.
SRS-BTD70
  1. Turn on the unit.
  2. Press and hold the VOLUME - button and the INPUT/PAIRING button at the same time for more than five seconds.

SRS-HG1
SRS-XB10
SRS-XB20
SRS-XB21
SRS-XB30
SRS-XB31
SRS-XB40
SRS-XB41
SRS-ZR5
SRS-ZR7
HT-ZR5P

  1. Turn on the unit.
  2. Press and hold the - (volume) button and the  (power) / PAIRING button at the same time for more than five seconds.

SRS-HG10

  1. Turn on the unit.
  2. Press and hold the + (volume) button and SET UP button at the same time for more than five seconds.
SRS-X1
  1. Turn on the unit.
  2. Press and hold the (previous) button, the (power) /PAIRING button, and the VOL + button at the same time for more than five seconds.

SRS-X11

  1. Turn on the unit.
  2. Press and hold the  (power) button, the VOL - button, and the VOL + button at the same time for more than five seconds.

SRS-X7
SRS-X9
SRS-X77
SRS-X88
SRS-X99

  1. Turn on the unit.
  2. Tap and hold the VOL - button and the ON/STANDBY button at the same time for more than five seconds.

SRS-XB2
SRS-XB3

  1. Turn on the unit.
  2. Press and hold the  (power) button and the VOLUME - button at the same time for more than five seconds.

SRS-XB60

  1. Turn on the unit.
  2. Press and hold the FUNCTION/ PAIRING button and the - (volume) button at the same time for more than five seconds.


NOTE: Depending on the model, once the wireless speaker is initialized it may enter standby mode.